La lecture en ligne est gratuite
Le téléchargement nécessite un accès à la bibliothèque YouScribe
Tout savoir sur nos offres
Télécharger Lire

ECSC SYMPOSIUM ON STEEL: Physical metallurgy: The service properties of steel: The utilization of steel

De
272 pages
Scientific and technical research
Target audience: Scientific
Voir plus Voir moins

Vous aimerez aussi

COMMISSION OF THE EUROPEAN COMMUNITIES
ECSC SYMPOSIUM
ON STEEL
Physical metallurgy
The service properties of steel
The utilization of steel
Luxembourg, 18-21 November 1975
Part 2 LEGAL NOTICE
The Commission of the European Communi­
ties is not responsible for the use which could
be made of the information presented in this
document. COMMISSION OF THE EUROPEAN COMMUNITIES
ECSC SYMPOSIUM
ON STEEL
Physical metallurgy
The service properties of steel
The utilization of steel
(Luxembourg, 18 to 21 November 1975)
Directorate General "Industrial and Technological Affairs'
Edited by the Directorate General
'Scientific and technical information and information management'
Luxembourg — September 1976
EUR 5401 d, e, f
Part 2
ΟίΕΜ*ΠΤ'ίί;:ρΓΗ
¿W033.CCQ CONTENTS
OPENING SESSION
Pages
— Welcoming address by Mr. Gaston Thorn
President of the Government of the Grand Duchy of Luxembourg 9
— Opening address by
E. VAN VEELEN, President du Conseil d'Administration, Estel-IJmuiden
«Future Challenges for the European Steel Industry " 13
— Introduction to the Symposium
by J.W. PETRICK, Head of the Steel Directorate of the Directorate-General
for Industrial and Technological Affairs 21
— The ECSC Iron and Steel Research Programme
P.R.V. EVANS, Head of the "Technical Research and Industrial Innovation"
Division—Directorate-General for Industrial and Technological Affairs 25
FIRST TECHNICAL SESSION
"Microstructure and properties of steel"
— Introduction by the Session Chairman
L HABRAKEN, Professor at the University of Liège—Deputy Director, Centre
de Recherches Métallurgiques, Liège 51
"Microstructure and properties of steel"
Dr. W. PITSCH, General rapporteur — Direktor am Max-Planck-lnst'rtut für
Eisenforschung GmbH, Düsseldorf (Part 1)
— Report and summary of the discussion
Dr. T. GLADMAN, Discussion leader. Head of Structure Studies Section Phy­
sical Metallurgy, British Steel Corporation — London 55
SECOND TECHNICAL SESSION
"Weldability — Brittle fracture"
1. WELDABILITY
— Introduction by the Session Chairman
0. MASI, Centro Sperimentale Metallurgico — Roma 75 "Weldability of steel"
A. CONSTANT, General rapporteur — Institut de Recherches de la Sidérurgie
Française, Saint-Germain-en-Laye
M. PRUDHOMME, Institut de Recherches de la Sidérurgie Française,
Saint-Germain-en-Laye (Part 1)
— Report and summary of the discussion
H. GRANJON, Discussion leader, Directeur Recherches Enseignement à l'In­
stitut de Soudure, Paris — Secrétaire scientifique et technique de l'IIS/IIW 77
2. BRITTLE FRACTURE
— Introduction by the Session Chairman
Dr. J.H. VAN DER VEEN, Directeur adjoint, Hoogovens IJmuiden 85
"Investigations into the sensitivity of steels to brittle fracture and their test­
ing"
Dr. Ing. W. ROHDE, General rapporteur — Verein Deutscher Eisenhüttenleute,
Düsseldorf
Dr. rer. nat. W. SCHLÜTER, Direktor, Verein Deutscher, Düs­
seldorf (Part 1)
— Report and summary of the discussion
W. DAHL, Discussion Leader, Institut für Eisenhüttenkunde, RWTH — Aachen 87
THIRD TECHNICAL SESSION
"Fatigue — Creep"
1. FATIGUE
— Introduction by the Session Chairman
A. CONSTANT, Institut de Recherches de la Sidérurgie Française, Saint-Ger­
main-en-Laye 101
" Community research on metal fatigue and standard structures from 1966-
1974"
A. BRAGARD, General rapporteur — Ingénieur-Chef de service au Centre de
Recherches Métallurgiques, Liège (Part 1)
— Report and summary of the discussion
R.V. SALKIN, Discussion leader, Ingénieur — Chef de service SA Cockerill,
Seraing3
2. CREEP
— Introduction by the Session Chairman
W. SCHLÜTER, Verein Deutscher Eisenhüttenleute, Düsseldorf 117
"ECSC Research activities 1966-1974 on high temperature steel"
F. RINALDI, General rapporteur — Capo Laboratorio di ricerca Dalmine S.pA
Milano (Part 1)
— Report and summary of the discussion
L MATTEOLI, Discussion leader, Post. Président de l'Associazione italiana di
metallurgia 118 FOURTH TECHNICAL SESSION
"Corrosion"
Introduction by the Session Chairman
H.J. ENGELL, Direktor des Max-Planck-Instituts für Eisenforschung GmbH,
Düsseldorf 153
"Research under the first, second and third joint ECSC programmes on cor­
rosion"
Prof. Dr. T. SONGA, General rapporteur — V. Direttore Generale, Istituto di
Ricerche Breda SpA, Milano, Bari (Part 1)
Report and summary of the discussion
H. ARUP, Discussion leader. Korrosionscentralen — Denmark 154
Concluding remarks
HJ. ENGELL, Direktor des Max-Planck-Instituts für Eisenforschung GmbH,
Düsseldorf9
FIFTH TECHNICAL SESSION
— Introduction by the Session Chairman
M. GROVES, British Steel Corporation, London 163
1. DRAWABILITY
"The cold formabilities of sheet"
M. BROZZO, General rapporteur — Centro Sperimentale Metallurgico, Roma (Part 1)
— Report and summary of the discussion
J. SUY, Discussion leader — Quality Control — Ford Motor Company, Genk 165
2. COLD-ROLLED SECTIONS
"Cold-formed steel sections"
Mr. DESCUDE, General rapporteur — Directeur du Comité Technique
Européen de profilage à froid des produits plats en acier, Paris (Part 1)
— Report and summary of the discussion
G.B. COLBRIDGE, Discussion leader — Constructional Steel Research and
Development Organisation (Constrado) — U.K. 185
3. SAFETY OF STRUCTURES (resistance to fire)
"Steel structures and fire"
J. WITTEVEEN, General rapporteur — Deputy Director, Institute TNO for
Building Materials and Building Structures, Delft (The Netherlands)
L TWILT, Research Engineer, Institute TNO for Building Materials and Build­
ing Structures, Delft (Part 1)
— Report and summary of the discussion
G.B. COLBRIDGE, Discussion leader — Constructional Steel Research and
Development Organisation (Constrado) — U.K. 191 — Concluding remarks
M. GROVES, British Steel Corporation, London 203
SIXTH TECHNICAL SESSION
"Industrialized building"
— Introduction by the Session Chairman
A. FUNÇK, Directeur d'Arbed Recherches — Luxembourg 207
1. TECHNICAL AND ADMINISTRATIVE OBSTACLES
"Technical and administrative obstacles to the use of industrialized housing"
H. HERBIET, General rapporteur — Président du Comité de Direction du Cen­
tre Belgo-Luxembourgeois d'Information de l'Acier — Bruxelles (Part 1)
— Report and summary of the discussion
G.B. COLBRIDGE, Discussion leader — Constructional Steel Research and
Development Organisation (Constrado) — U.K. 209
2. RESEARCH ON INDUSTRIALIZATION
"Industrialized building — research on industrialized prototypes and building
components"
M. BOURGUIGNON, General rapporteur — Sous-Directeur du Centre Belgo-
Luxembourgeois d'Information de l'Acier — Bruxelles (Part 1)
— Concluding remarks
A. FUNCK, Directeur d'Arbed Recherches — Luxembourg 215
CLOSING SESSION
— Summary of the Symposium
MJ. MAY, British Steel Corporation, London 219
— Closing Address
P.R.V. EVANS, Head of Technical Research and Industrial Innovation Division
Directorate-General for Industrial and Technological Affairs 225
— List of publications
— List of participants OPENING SESSION
Welcoming address by Mr. Gaston Thorn
President of the Government of the Grand Duchy of Luxembourg
Opening address by
E. VAN VEELEN, Président du Conseil d'Administration, Estel-IJmuiden
« Future Challenges for the European Steel Industry
Introduction to the Symposium
by J.W. PETRICK, Head of the Steel Directorate of the Directorate-General for Industrial
and Technological Affairs
The ECSC Iron and Steel Research Programme
P.R.V. EVANS, Head of the "Technical Research and Industrial Innovation" Division—Di­
rectorate-General for Industrial and Technological Affairs

Un pour Un
Permettre à tous d'accéder à la lecture
Pour chaque accès à la bibliothèque, YouScribe donne un accès à une personne dans le besoin