La lecture en ligne est gratuite
Le téléchargement nécessite un accès à la bibliothèque YouScribe
Tout savoir sur nos offres
Télécharger Lire

Manuel de base - Olympus C-220 ZOOM

De
180 pages

Notice utilisateur, mode d'emploi du modèle 'C-220 ZOOM' de marque 'Olympus'

Publié par :
Ajouté le : 28 mai 2011
Lecture(s) : 190
Signaler un abus

basic_e_d.fm Page 1 Tuesday, February 12, 2002 4:29 PM
ENGLISHC-2 Zoom
FRANÇAIS
D-520 ZOOM
DEUTSCH
C-220 ZOOM
ESPAÑOLbasic_e_d.fm Page 2 Tuesday, February 12, 2002 4:29 PM
CONTENTS/TABLE DES MATIÉRES/INHALT/CONTENIDO/
ENGLISH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
FRANÇAIS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
DEUTSCH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
ESPAÑOL . . . . . . . . . . . . . . . . 110
En
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 146
CONTENTS
GETTING STARTED . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
MENU FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
SHOOTING BASICS . . . . . . . . . . . . . . . . . . . 18
SELECTING THE IMAGE QUALITY (RECORD MODE) 23
PLAYBACK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
PRINT SETTINGS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
DOWNLOADING PICTURES TO A COMPUTER . . . . . 31
OPTIONAL ACCESSORIES . . . . . . . . . . . . . . . . . . . . . 33
ERROR CODES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
SPECIFICATIONS . . . . . . . . . . 36
These instructions are only for quick reference. For more details
on the functions described here, refer to the “Reference Manual”
on CD-ROM.
2 Enbasic_e_d.fm Page 3 Tuesday, February 12, 2002 4:29 PM
For customers in Europe
“CE” mark indicates that this product complies with the European
requirements for safety, health, environment and customer
protection. “CE” mark cameras are intended for sales in Europe.
For customers in North and South America
For customers in USA
En
Declaration of Conformity
Model Number : C-2 Zoom/D-520 ZOOM/C-220 ZOOM
Trade Name : OLYMPUS
Responsible Party : Olympus America Inc.
Address : 2 Corporate Center Drive, Melville, New York
11747-3157 U.S.A.
Telephone Number: 631-844-5000
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
For customers in Canada
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Trademarks
• IBM is a registered trademark of International Business Machines Corporation.
• Microsoft and Windows are registered trademarks of Microsoft Corporation.
• Macintosh is a trademark of Apple Computer Inc.
• All other company and product names are registered trademarks and/or
trademarks of their respective owners.
• The standards for camera file systems referred to in this manual are the “Design
Rule for Camera File System/DCF” standards stipulated by the Japan Electronics
and Information Technology Industries Association (JEITA).
En 3basic_e_d.fm Page 4 Tuesday, February 12, 2002 4:29 PM
GETTING STARTED
NAMES OF PARTS
Shutter Lens Flash
Extends automatically when button Pops up when you
En you open the lens barrier. open the lens barrier.
Connector cover
Zoom
lever USB connector
VIDEO
OUT jackLens barrier
Turns the camera on and
off in the shooting mode.
Self-timer lamp DC-IN jack
Orange lamp
Viewfinder Green lamp
AF target mark
Card cover
Strap eyelet
Monitor
Battery
compartment
cover
Arrow pad
Tripod socket
(Monitor) button
Turns the camera on and
(OK/Menu) button
off in the playback mode.
4 En
Jbasic_e_d.fm Page 5 Tuesday, February 12, 2002 4:29 PM
MONITOR INDICATIONS
Shooting mode Playback mode
13
51 141
8
2 6 10
7 5
7 En3
11
4 8 12
9
Item Indication
1 Battery check ,
2 Flash , , , ,
3 Spot metering
4 Memory gauge
5 Exposure compensation -2.0, -1.5, -1.0, -0.5, +0.5, +1.0, +1.5, +2.0
6 Self-timer/Drive , ,
7 White balance WB AUTO, , , ,
8 Record mode SHQ, HQ, SQ1, SQ2
Number of storable still
9 16/16"pictures/Seconds remaining
10 Number of pixels 1600 × 1200, 1024 × 768, 640 × 480
11 Date and time '02.01.12 12:30
File number, Frame number/
12 100-0016, 16/16"Playing time
13 Print reservation, Number of prints × 2
14 Protect
You can view shooting information details of the recorded picture in the
playback mode.
En 5
Jbasic_e_d.fm Page 6 Tuesday, February 12, 2002 4:29 PM
Memory gauge
The memory gauge lights up when you take a picture. While the gauge is lit,
the camera is storing the picture on the card. The memory gauge indication
changes as shown below depending on the shooting status. When the
memory gauge is full, wait a few moments before taking the next shot.
When taking still pictures
En
Shoot Shoot Shoot
Wait
Before One picture More than No more pictures
shooting taken two taken can be taken
(Gauge is (Lit) (Lit) (Fully Lit)
off)
When recording movies
If you continue shooting
Shoot
Wait
Before shooting During shooting (Lit)
• Shooting is not possible until the lit area goes off completely.(Gauge is off)
• Movie recording ends automatically when the memory gauge
is full.
Battery check
If the remaining battery power is low, the battery check indication on the
monitor changes as follows while the camera is turned on.
No indication
Lights up (Green) Blinks (Red) Green lamp and Orange
lamp on the right of the Remaining power Remaining power level: low
viewfinder blinklevel: high Replace with a new battery.
Remaining power level:
exhausted
6 Enbasic_e_d.fm Page 7 Tuesday, February 12, 2002 4:29 PM
ATTACHING THE STRAP
1 Thread the short end of the strap
through the strap eyelet.
2 Thread the long end of the strap
through the loop that has already gone the eyelet.
En
3 Pull the strap tight, making sure that it
is securely fastened and does not
come loose.
LOADING THE BATTERIES
1 Make sure that:
• The monitor is off.
• The lens barrier is closed.
• The lamp on the right of the viewfinder is off.
2 Slide the battery compartment Battery
cover in the direction of (the insertion
direction direction indicated by the
markmark on the cover), and lift it up in
the direction of .
3 Insert the batteries, making sure
that they are correctly oriented as shown in the illustration.
When using When using
AA (R6) a lithium
batteries battery pack
4 Close the battery compartment cover in the
direction of . While pressing the
mark, slide the cover in the direction of .
If the battery compartment cover will not close
easily, do not force it. Try pressing the mark
with both hands.
En 7
JJbasic_e_d.fm Page 8 Tuesday, February 12, 2002 4:29 PM
AA (R6) alkaline batteries
The number of pictures that you can store in the camera may vary
considerably with AA batteries, depending on the battery manufacturer,
camera shooting conditions, etc. Use this type of battery only when you have
no other choices available. Turn off the monitor whenever possible to save
power.
En INSERTING THE CARD (SmartMedia)
The pictures you have taken are stored on the card.
1 Make sure that:
• The monitor is off.
• The lens barrier is closed.
• The lamp on the right of the viewfinder is off.
2 Open the card cover.
3 Insert the card as far as it will go in
the direction shown in the
illustration.
There is an arrow inside the card cover,
indicating the direction in which the card
should be inserted.
4 Close the card cover securely until Card insertion
direction markit clicks.
8 En
Jbasic_e_d.fm Page 9 Tuesday, February 12, 2002 4:29 PM
TURNING THE POWER ON/OFF
When shooting pictures
Power on: Open the lens barrier.
The camera turns on in the shooting mode. The lens extends
and the flash pops up.
If the lens does not extend, the lens barrier is not fully open. En
Open the lens barrier until it clicks.
If the date and time have reverted to the
factory default settings, Y/M/D appears
on the monitor.
Power off: Close the lens barrier slightly until it just touches the lens
barrier.
The lens barrier stops just before it touches the lens and the lens
retracts. Wait until the lens is fully retracted before closing the
lens barrier completely.
The camera turns off. (The monitor also turns off.)
Press the flash down manually until it locks in place.
Do not push the lens barrier forcefully against the lens as this may damage
the lens or cause it to malfunction.
En 9
Jbasic_e_d.fm Page 10 Tuesday, February 12, 2002 4:29 PM
When playing back pictures
Power on: Press the (monitor) button with the lens barrier closed.
The camera turns on in the playback mode. The monitor turns
on and the last picture taken is displayed.
En
(monitor) button
Power off: Press the (monitor).
The monitor and the camera turn off.
(monitor) button
Never open the card cover, remove the card or the batteries, or connect or
disconnect the AC adapter while the camera is turned on. Doing so could
destroy all data on the card. Destroyed data cannot be restored. When
changing the card, be sure to turn the camera off before opening the card
cover.
10 En