Millie Hat
1 page
English

Millie Hat

-

Le téléchargement nécessite un accès à la bibliothèque YouScribe
Tout savoir sur nos offres

Description

Millie Hat. Materials: 100g Cascade Eco Cloud. Needles: 5mm (US 8) straight, 5mm (US 8) 40cm circular and 5mm (US 8) double point. One cable needle.

Sujets

Informations

Publié par
Nombre de lectures 161
Langue English
Millie Hat
Materials:
100g Cascade Eco Cloud
Needles:
5mm (US 8) straight, 5mm (US 8)
40cm circular and 5mm (US 8) double point.
One cable needle.
Tension:
18 sts = 4” on 5mm (US 8) needles
Sized to fit average adult
Abbreviations
C12F = Cable 12 to the front. Slip 6 sts onto
cable needle and hold in front of work. Knit
next 6 sts from left hand needle, then knit 6
sts from the cable needle.
SSK = Slip two sts one at a time, knitwise from
the left to right needle. Insert the left needle
into the front of the two slipped sts and knit
them together on the right needle.
Cable Panel:
With 5mm (US 8) straight needles and waste
yarn, cast on 30 sts using the backward “e”
method (make a loop over your right index
finger, crossing the yarn at the bottom of the
loop then place on the left needle). This will be
a provisional cast on that will be undone when
the cable panel is finished.
Continue with Eco Cloud and work in cable
pattern as follows:
Row 1: Slip 1 st, P1, (K12, P2) twice.
Row 2 and all even number rows: Slip 1 st, K1,
(P12, K2) twice.
Row 3: As Row 1.
Row 5: Slip 1 st, P1, (C12F, P2) twice.
Row 7, 9 and 11: As Row 1.
Row 12: As Row 2.
Repeat these 12 rows a total of 11 times.
Unpick the waste yarn from the provisional cast
on and graft the cast on edge to the last row of
knitting or you can also use the 3 needle bind
off technique to join the two ends.
Hat Band:
With 40 cm circular needle, pick up and knit 1
st in each of the slipped sts along one long
edge of the cable panel. 66 sts. Work in rounds
of Seed Stitch as follows:
Rnd 1: (K1, P1) 33 times.
Rnd 2: (P1, K1) 33 times.
Repeat these two rows for a total of 6 rnds.
Cast off loosely.
Hat Crown:
Work as given for Hat Band. When the 6 rnds of
Seed Stitch have been completed,
decrease the crown as follows:
Rnd 1: Place marker, (SSK, K9) 6 times.
On following rnds, slip the markers and SSK the
next 2 sts while knitting the remaining sts.
When the stitches become too few to use the
circular needle, change to double points and
continue decreasing until there are 6 sts
remaining. Break yarn. Weave the yarn end
through the last 6 sts and draw closed. Sew in
yarn ends.
Millie Hat by Ram Wools Yarn Co-op is licensed
under a Creative Commons Attribution-
ShareAlike 3.0