Quickstart Guide: Powering SuperTalker Select Level and Grid1 2SuperTalker™ progressive communicator Adjust as-needed With the desired Overlay and Keyguard in place: Select a LEVEL (1-8) and Grid (1, 2, 4, 8) using the Power controls on the spine of the device. NOTE: Be sure to match the Grid number to the Keyguard and Overlay currently installed on the device. Insert four AA batteries into the device as shown. Power For information on Overlays, Keyguards and Helpful Tips, see On/Off is located on the spine of the device. reverse. Overlays and ideas at www.ablenetinc.com Enter Record Mode Record Messages Exit Record Mode3 4 5 Press and Hold while speaking Press and Hold, Press and then Release Release Press and Hold the RECORD button until the RECORD Press and Hold the desired Message location, begin Press and Release the RECORD button to exit Record Light activates, then Release. speaking when you hear a beep. Release when finished. Mode. NOTE: This device has 16 minutes of total recording time. Repeat for additional messages. The RECORD Light will turn yellow when only two minutes RECORD Light will flash while recording. remain. NOTE: Speak close to the microphone for loud, clear sound. Advanced Features Product Map and Warranty Top ViewPlaying a message with an External Switch Microphone Attach the switch of your choice with a 1/8-inch (3.5mm) to the RECORD LightSwitch Input jacks and continue to use the device as before.